Users Guide

Version Description
8.3.12.0 Introduced on the S4810. Added support for source-interface
for link-local IPv6 addressing.
8.3.11.1 Introduced on the Z9000.
8.2.1.0 Introduced on the E-Series (IPv6). Increased the number of
VLANs to 4094 (was 2094).
8.1.1.0 Introduced on the E-Series (IPv4).
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series and added support for IPv6 address
on the E-Series only.
Usage Information
The VRF configured using this command has a higher precedence than a VRF
configured using the ip telnet vrf vrf-name command. If you do not use the VRF
attribute in this command, then TELENT client uses the VRF configured using the ip
telnet vrf vrf-name
command.
The source interface configured using this command has a higher precedence than the
source interface configured using the ip telnet source-interface command. If
you do not configure a source interface using this command, then the TELNET client
uses the source interface configured using the ip telnet source-interface
command.
In case there is a mismatch between the VRF telnet source interface and the telnent
VRF, then an error is reported.
Example
Dell# telnet vrf vrf1 10.10.10.2
telnet-peer-stack-unit
Open a Telnet connection to the peer stack unit.
Syntax
telnet-peer-stack-unit
Defaults Not configured.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Control and Monitoring 183