Users Guide

debug protocol-tunnel
Enable debugging to ensure incoming packets are received and rewritten to a new MAC address.
Syntax
debug protocol-tunnel interface {in | out | both} [vlan vlan-id]
[count value]
To disable debugging, use the no debug protocol-tunnel interface {in |
out | both} [vlan vlan-id] [count value] command.
Parameters
interface Enter one of the following interfaces and the interface
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port-channel interface, enter the keywords port-
channel
then the port-channel ID.
in | out | both Enter the keyword in, out, or both to debug incoming
interfaces, outgoing interfaces, or both incoming and outgoing
interfaces.
vlan vlan-id Enter the keyword vlan then the VLAN ID. The range is from 1
to 4094.
count value Enter the keyword count then the number of debug outputs.
The range is from 1 to 100.
Defaults Debug disabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Service Provider Bridging 1829