Users Guide

Version Description

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.5(0.0) Introduced on the Z9000, S6000, S4820T, S4810, and MXL.

Usage Information

By default, access to commands are determined by the user’s role (if defined) or by the

user’s privilege level. If the aaa authorization role-only command is enabled,

then only the user’s role is used.

Before you enable role-based only AAA authorization:

1 Locally define a system administrator user role.This will give you access to login

with full permissions even if network connectivity to remote authentication servers

is not available.

2 Configure login authentication on the console. This ensures that all users are

properly identified through authentication no matter the access point

3 Specify an authentication method (RADIUS, TACACS+, or Local).

4 Specify authorization method (RADIUS, TACACS+ or Local).

5 Verify the configuration has been applied to the console or VTY line.

Commands

enable

Enter EXEC Privilege mode or any other privilege level configured. After entering this command, you may

need to enter a password.

Syntax

enable [level]

Parameters

level (OPTIONAL) Enter a number for a privilege level of Dell

Networking OS. The range is from 0 to 15.

Defaults 15

Command Modes EXEC

Command History

This guide is platform-specific. For command information about other platforms, see

the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.8(1.0) Introduced on the Z9100–ON.

Security 1821