Users Guide

Parameters
vrf management Enter the keyword vrf followed by the keyword management to
configure an SSH server on a management VRF.
vrf vrf-name Enter the keyword vrf followed by the VRF name to configure
an SSH server on that VRF.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S-Series and Z9000.
Usage Information
You can enable the SSH server on either a management VRF or a user defined VRF but
not both. If no VRF is specified, then the SSH server is enabled on the default VRF.
If the SSH server is enabled on a VRF with name vrf1, then use the following command
to restart the SSH server on a VRF with name vrf2: ip ssh server vrf vrf2. If the
SSH server is enabled on a VRF with name vrf1, then use the following command to
restart the SSH server on the default VRF: ip ssh server vrf.
Example
• Dell(conf)# ip ssh server vrf vrf1
• Dell(conf)# no ip ssh server vrf
• Dell(conf)# ip ssh server vrf management
• Dell(conf)# no ip ssh server vrf
Related
Commands
• show ip ssh — displays the ssh information.
ip ssh source-interface
Specifies an interface’s IP address as the source IP address for an outgoing SSH connections.
Syntax
ip ssh source-interface interface
To delete a source interface, use the no ip ssh source-interface command.
Security 1801