Users Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Example
Dell#conf
Dell(conf)# ip ssh rhostsfile flash://shosts
Dell(conf)#
Usage Information
This command specifies the rhost file used for host-based authentication. This
creates/ file overwrites the flash:/ADMIN_DIR/ssh/shosts file and deletes the
user-specified file. Even though this command is a global configuration command, it
does not appear in the running configuration because you only need to run this
command once.
This file contains hostnames and usernames, for which hosts and users, rhost-
authentication can be allowed.
NOTE: For rhostfile and pub-key-file, the administrator must FTP the file
to the switch.
ip ssh rsa-authentication (Config)
Enable RSA authentication for the SSHv2 server.
Syntax
ip ssh rsa-authentication enable
To disable RSA authentication, use the no ip ssh rsa-authentication enable
command.
Parameters
enable Enter the keyword enable to enable RSA authentication for the
SSHv2 server.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Security 1796