Users Guide

• If 802.1X is disabled on the port, it is returned to the configured access VLAN.
• When the port is in the Force Authorized, Force Unauthorized, or Shutdown state, it is placed in the
configured access VLAN.
• If an 802.1X port is authenticated and put in the RADIUS server assigned VLAN, any change to the port
access VLAN configuration does not take effect.
• The 802.1X with VLAN assignment feature is not supported on trunk ports, dynamic ports, or with
dynamic-access port assignment through a VLAN membership.
dot1x authentication (Configuration)
Enable dot1x globally; dot1x must be enabled both globally and at the interface level.
Syntax
dot1x authentication
To disable dot1x on globally, use the no dot1x authentication command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the C-Series and S-Series.
7.4.1.0 Introduced on the E-Series.
Related
Commands
• dot1x authentication (Interface) — enable dot1x on an interface.
Security 1770