Users Guide

Version Description
7.6.1.0 Introduced on the E-Series.
Example
Dell# show running-config rip
!
router rip
distribute-list Test1 in
distribute-list Test21 out
network 10.0.0.0
passive-interface GigabitEthernet 2/1
neighbor 20.20.20.20
redistribute ospf 999
version 2
Dell#
timers basic
Manipulate the RIP timers for routing updates, invalid, holddown times, and flush time.
S4048–ON
Syntax
timers basic update invalid holddown flush
To return to the default settings, use the no timers basic command.
Parameters
update Enter the number of seconds to specify the rate at which RIP
routing updates are sent. The range is from zero (0) to
4294967295. The default is 30 seconds.
invalid Enter the number of seconds to specify the time interval before
routing updates are declared invalid or expired. The invalid value
should be at least three times the update timer value. The range
is from zero (0) to 4294967295. The default is 180 seconds.
holddown Enter the number of seconds to specify a time interval during
which the route is marked as unreachable but still sending RIP
packets. The holddown value should be at least three times the
update timer value. The range is from zero (0) to 4294967295.
The default is 180 seconds.
flush Enter the number of seconds to specify the time interval during
which the route is advertised as unreachable. When this interval
expires, the route is flushed from the routing table. The flush
value should be greater than the update value. The range is from
zero (0) to 4294967295. The default is 240 seconds.
Routing Information Protocol (RIP) 1676