Users Guide

Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 7.7.1.0 Introduced on the E-Series.
Related
Commands
• router rip — enters ROUTER mode on the switch.
distance
Assign a weight (for prioritization) to all routes in the RIP routing table or to a specific route. Lower weights
(“administrative distance”) are preferred.
S4048–ON
Syntax
distance weight [ip-address mask [prefix-name]]
To return to the default values, use the no distance weight [ip-address mask]
command.
Parameters
weight Enter a number from 1 to 255 for the weight (for prioritization).
The default is 120.
ip-address (OPTIONAL) Enter the IP address, in dotted decimal format
(A.B.C.D), of the host or network to receive the new distance
metric.
Routing Information Protocol (RIP) 1652