Users Guide

debug ip rip
Examine RIP routing information for troubleshooting.
S4048–ON
Syntax
debug ip rip [interface | database | events [interface] | trigger]
To turn off debugging output, use the no debug ip rip command.
Parameters
interface (OPTIONAL) Enter the interface type and ID as one of the
following:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number.
• For a VLAN, enter the keyword vlan then a number from 1
to 4094.
database (OPTIONAL) Enter the keyword database to display messages
when there is a change to the RIP database.
events (OPTIONAL) Enter the keyword events to debug only RIP
protocol changes.
trigger (OPTIONAL) Enter the keyword trigger to debug only RIP
trigger extensions.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
Routing Information Protocol (RIP) 1648