Users Guide

peak peak-rate (OPTIONAL) Enter the keyword peak then a number to specify
the peak rate in Mbps. The range is from 0 to 40000. The default
is the same as designated for committed-rate.
Defaults Burst size is 100KB. peak-rate is by default the same as committed-rate.
Granularity for committed-rate and peak-rate is Mbps unless you use the kbps
option.
Command Modes QOS-POLICY-IN
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage Information The default burst size is 100Kb. If a different value is required, you must configure the
burst size to the required value.
Related
Commands
• rate police — specifies traffic policing on the selected interface.
• qos-policy-input — creates a QoS output policy.
Quality of Service (QoS) 1611