Users Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Added the keyword multicast . Added support for the DSCP
Marking option for the S-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series. Added support for the DSCP
Marking option.
6.1.1.1 Introduced on the E-Series.
Usage Information
To access this command, enter the class-map command. After the class map is
identified, you can configure the match criteria.
The match ip precedence command and the match ip dscp command are
mutually exclusive.
Up to eight precedence values can be matched in one match statement. For example,
to indicate the IP precedence values 0 1 2 3, enter either the match ip precedence
0-3 or match ip precedence 0,1,2,3 command.
NOTE: Only one of the IP precedence values must be a successful match
criterion, not all of the specified IP precedence values must match.
Related
Commands
• class-map — identifies the class map.
match ip vlan
Uses a VLAN as the match criterion for an L3 class map.
S4048–ONS4048–ON
Syntax match ip vlan vlan-idTo remove VLAN as the match criterion, use the no match
ip vlan vlan-id command.
Parameters
vlan vlan-id Enter the keyword vlan and then the ID of the VLAN. The range
is from 1 to 4094.
Defaults None.
Quality of Service (QoS) 1597