Users Guide

Related
Commands
• class-map — identifies the class map.
match ip precedence
Use IP precedence values as a match criteria.
S4048–ON
Syntax
match {ip | ipv6 | ip-any} precedence ip-precedence-list [set-ip-
dscp value]
To remove IP precedence as a match criteria, use the no match {ip | ipv6 | ip-
any} precedence ip-precedence-list [[multicast] set-ip-dscp value]
command.
Parameters
ip Enter the keyword ip to support IPv4 traffic.
ipv6 Enter the keyword ipv6 to support IPv6 traffic.
ip-any Enter the keyword ip-any to support IPv4 and IPv6 traffic.
ip-precedence-
list
Enter the IP precedence value(s) as the match criteria. Separate
values by commas — no spaces ( 1,2,3 ) or indicate a list of
values separated by a hyphen (1-3). The range is from 0 to 7.
set-ip-dscp value (OPTIONAL) Enter the keywords set-ip-dscp then the IP
DSCP value. The matched traffic is marked with the DSCP value.
The range is from 0 to 63.
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Added support for the ipv6 and ip-any options on the Z9000,
S6000, S4820T, S4810, MXL.
Quality of Service (QoS) 1596