Users Guide

Version Description

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.7.1.0 Added the DSCP Marking option support on the S-Series.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series; added support for the DSCP

Marking option.

6.1.1.1 Introduced on the E-Series.

Usage Information To access this command, enter the class-map command. After the class map is

identified, you can configure the match criteria. For class-map match-any, a maximum

of five ACL match criteria are allowed. For class-map match-all, only one ACL

match criteria is allowed.

Commands

• class-map — identifies the class map.

match ip dscp

Use a differentiated services code point (DSCP) value as a match criteria.

S4048–ON

Syntax

match {ip | ipv6 | ip-any} dscp dscp-list [set-ip-dscp value]

To remove a DSCP value as a match criteria, use the no match {ip | ipv6 | ip-

any} dscp dscp-list [[multicast] set-ip-dscp value] command.

Parameters

ip Enter the keyword ip to support IPv4 traffic.

ipv6 Enter the keyword ipv6 to support IPv6 traffic.

ip-any Enter the keyword ip-any to support IPv4 and IPv6 traffic.

dscp-list Enter the IP DSCP values that is to be the match criteria.

Separate values by commas — no spaces ( 1,2,3 ) or indicate a

list of values separated by a hyphen (1-3). The range is from 0 to

63.

Quality of Service (QoS) 1594