Users Guide

• qos-policy-output — creates an output QoS-policy on the router.
• wred-profile — creates a WRED profile.
match ip access-group
Configure match criteria for a class map, based on the access control list (ACL).
NOTE: IPv6 class-maps and IP-any class-maps do not match. This condition is true for IPv6 and IP-any
class-maps on both ACLs as well as VLANs.
S4048–ON
Syntax
match ip access-group access-group-name [set-ip-dscp value | set-
color value]
To remove ACL match criteria from a class map, use the no match ip access-
group access-group-name [set-ip-dscp value | set-color value]
command.
Parameters
access-group-
name
Enter the ACL name whose contents are used as the match
criteria in determining if packets belong to the class the class-
map specifies.
set-ip-dscp value (OPTIONAL) Enter the keywords set-ip-dscp then the IP
DSCP value. The matched traffic is marked with the DSCP value.
The range is from 0 to 63.
set-color value (Optional) Enter the keyword set-color followed by a color
value. Traffic that fulfills the match criteria is marked with the
color value that you specify. The default value is Yellow.
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
Quality of Service (QoS) 1593