Users Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information To apply dot1p-queue-mapping, use the service-class dynamic dot1p
command.
Related
Commands
• show qos dot1p-queue-mapping — displays the dot1p priority to queue mapping
on the switch.
service-class dynamic dot1p
Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all
interfaces (from CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE mode
entry.
S4048–ON
Syntax
service-class dynamic dot1p
To return to the default setting, use the no service-class dynamic dot1p
command.
Defaults All dot1p traffic is mapped to Queue 0 unless you enable the service-class
dynamic dot1p command. The default mapping is as follows:
dot1p Queue ID
0 0
1 0
2 0
3 1
4 2
5 3
6 3
7 3
Command Modes
• INTERFACE
• CONFIGURATION
Quality of Service (QoS) 1585