Users Guide

Usage Information

If traffic is shaped between 64 and 1000 Kbs, for some values, the shaped rate is much

less than the value configured.

On 40-port 10G stack-unit if the traffic is shaped between 64 and 1000 Kbs, for some

values, the shaped rate is much less than the value configured.

NOTE: When packets of size greater than 7000 bytes are expected to be received

from the network, Dell Networking recommends that you configure the burst

value to be more than 175 KB if you configured the rate shape. Such a setting

ensures proper bandwidth sharing across queues.

Commands

• rate-shape — shapes traffic output as part of the designated policy.

service-class dot1p-mapping

Configure a service-class criterion based on a dot1p value.

S4048–ON

Syntax

service-class dot1p-mapping {dot1p0 queue | dot1p1 queue | dot1p2

dot1p7 queue}

Parameters

queue Enter a value from 0 to 7.

Defaults For each dot1p Priority, the default CoS queue value is:

• Dot1p Priority : 0 1 2 3 4 5 6 7

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, see

the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

Quality of Service (QoS) 1584