Users Guide

vlan vlan-id (OPTIONAL) Enter the keyword vlan then a VLAN ID to police
traffic to those specific VLANs. The range is from 1 to 4094.
Defaults Granularity for commited-rate and peak-rate is Mbps unless you use the kbps
option.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage Information
NOTE: Per Port rate police is supported for Layer 2 tagged and untagged
switched traffic and for Layer 3 traffic. Per VLAN rate police is supported on only
tagged ports with Layer 2 switched traffic.
S-Series
On one interface, you can configure the rate police command for a VLAN or you
can configure the rate police command for an interface.
Quality of Service (QoS) 1582