Users Guide

show ip pim snooping neighbor
Display information on PIM neighbors learned through PIM-SM snooping.
Syntax
show ip pim snooping neighbor [vlan vlan-id]
Parameters
vlan vlan-id (OPTIONAL) Enter a VLAN ID to display information about PIM
neighbors that PIM-SM snooping discovered on a specified
VLAN. The valid VLAN IDs range is from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.4.1.1 Introduced on the E-Series.
Usage Information The following describes the show ip pim snooping neighbor commands shown
in the following example.
Field Description
Neighbor address Displays the IP address of the neighbor learned through PIM-SM
snooping.
Interface Displays the VLAN ID number and slot/port on which the PIM-
SM-enabled neighbor was discovered.
Uptime/expires Displays the amount of time the neighbor has been up then the
amount of time until the neighbor is removed from the multicast
routing table (that is, until the neighbor hold time expires).
Ver Displays the PIM version number:
• v2 = PIM version 2
DR prio/Mode Displays the Designated Router priority and the mode:
PIM-Sparse Mode (PIM-SM) 1533