Users Guide

• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port-channel interface, enter the keywords port-
channel
then the port-channel ID.
• For a VLAN, enter the keyword vlan then a number from 1
to 4094.
priority (OPTIONAL) Enter the priority used in Bootstrap election
process. The range is zero (0) to 255. The default is 192.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the S-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage Information Priority is stored at BSR router when receiving a Candidate-RP-Advertisement.
ip pim sparse-mode
Enable PIM sparse mode and IGMP on the interface.
Syntax
ip pim sparse-mode
PIM-Sparse Mode (PIM-SM) 1520