Users Guide

tunnel-id Enter the keyword tunnel-id to redirect the traffic.
track Enter the keyword track to enable the tracking.
track <obj-id> Enter the keyword track <obj-id> to track object-id.
ip-protocol-
number
Enter a number from 0 to 255 for the protocol identified in the
IP protocol header.
protocol-type Enter one of the following keywords as the protocol type:
• icmp for internet control message protocol
• ip for any internet protocol
• tcp for transmission control protocol
• udp for user datagram protocol
bit (OPTIONAL) For the TCP protocol type only, enter one or a
combination of the following TCP flags:
• ack = acknowledgement
• fin = finish (no more data from the user)
• psh = push function
• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent field
source Enter the IP address of the network or host from which the
packets were sent.
mask Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all traffic is subject to the
filter.
host ip-address Enter the keyword host then the IP address to specify a host IP
address.
destination Enter the IP address of the network or host to which the packets
are sent.
operator (OPTIONAL) For TCP and UDP parameters only. Enter one of the
following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two
ports for theport command parameter.)
Defaults None
Policy-based Routing (PBR) 1500