Users Guide

Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series.
7.5.1.0 Introduced on the E-Series.
redirect
Configure a rule for the redirect list.
Syntax
redirect {ip-address | slot/port} | tunnel tunnel-id}[track <obj-
id>] {ip-protocol-number | protocol-type [bit]} {source mask | any
| host ip-address} {destination mask | any | host ip-address}
[operator]
To remove this filter, use one of the following:
• Use the no seq sequence-number command if you know the filter’s sequence
number.
• You can also use the no redirect {ip-address | slot/port}| tunnel
tunnel-id}[track <obj-id>] {ip-protocol-number [bit] |
protocol-type} {source mask | any | host ip-address}
{destination mask | any | host ip-address} [operator] command.
Parameters
redirect Enter the keyword redirect to assign the sequence to the
redirect list.
ip-address Enter the IP address of the forwarding router.
slot/port Enter the keyword slot / port followed by the slot/port
information.
tunnel Enter the keyword tunnel to configure the tunnel setting.
Policy-based Routing (PBR) 1499