Users Guide

Version Description
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
9.1(0.0) Added ‘conditional’ parameter.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information
If you use only the reload command, the system boots into the Dell Networking OS.
If there is a change in the running configuration, the system prompts you to save the
new configuration when you reload the system using the reload command. You can
also save your running configuration manually using the
copy running-config
command.
You can use the conditional parameter if any configuration changes made to the
NVRAM, such as, stack-group and fanout configurations, must be saved.
Example
The following example shows how to reload the system:
Dell# reload
Proceed with reload [confirm yes/no]: yes
The following example shows how to reload the system into Dell diagnostics mode:
Dell#reload dell-diag
Proceed with reload [confirm yes/no]: yes
The following example shows how to reload the system into ONIE mode:
Dell#reload onie
Proceed with reload [confirm yes/no]: yes
The following example shows how to reload the system into ONIE prompt and enter
the install mode directly:
Dell#reload onie install
Proceed with reload [confirm yes/no]: yes
Control and Monitoring 148