Users Guide

remote system. The range is from 50 to 1000. The default is
200.
multiplier value Enter the keyword multiplier to specify the number of
packets that must be missed in order to declare a session down.
The range is from 3 to 50. The default is 3.
role [active |
passive]
Enter the role that the local system assumes:
• Active — active system initiates the BFD session. Both
systems can be active for the same session.
• Passive — passive system does not initiate a session. It
only responds to a request for session initialization from
the active system.
The default is Active.
Defaults See Parameters.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2.0.0 Introduced on the Z9000, S4820T, and S4810.
Usage Information
This command provides the flexibility to fine-tune the timer values based on individual
interface needs when you configure ipv6 ospf BFD in CONFIGURATION mode. Any
timer values specified with this command overrides timers set using the bfd all-
neighbors command. Using the no form of this command does not disable BFD if you
configure BFD in CONFIGURATION mode.
To disable BFD on a specific interface while you configure BFD in CONFIGURATION
mode, use the keyword disable.
ipv6 ospf cost
Explicitly specify the cost of sending a packet on an interface.
Syntax
ipv6 ospf interface-cost
Open Shortest Path First (OSPFv2 and OSPFv3) 1469