Users Guide

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series and E-Series.
Usage Information
This command is useful in isolating routing problems between the OSPF and the RTM.
For example, if a route is missing from the RTM/FIB but is visible from the display output
of this command, the problem is with downloading the route to the RTM.
This command has the following limitations:
• The display output is sorted by prefixes; intra-area ECMP routes are not displayed
together.
• For Type 2 external routes, Type 1 cost is not displayed.
NOTE: Starting with Version 9.4(0.0), the loopback IP address advertised to the
neighbor is not displayed in the output because they are not accounted as
inactive OSPF routes, whereas the loopback IP address is displayed until Dell
Networking OS Version 9.3(0.0). Starting with Version 9.4(0.0), the show ip ospf
routes command displays the interface and area ID information of connected
networks in addition to the other settings, whereas these details are not displayed
until Dell Networking OS Version 9.3(0.0). Starting with Version 9.4(0.0), the
metric of E2 routes in the output is displayed as an external metric, whereas until
Dell Networking OS Version 9.3(0.0), the number of hops to the ASBR for E2
routes are displayed in the output.
Example
Dell# show ip ospf 100 route
Prefix Cost Nexthop Interface Area Type
1.1.1.1 1 0.0.0.0 Lo 0 0 Intra-Area
3.3.3.3 2 13.0.0.3 Te 1/47 1 Intra-Area
13.0.0.0 1 0.0.0.0 Te 1/47 0 Intra-Area
150.150.150.0 2 13.0.0.3 Te 1/47 - External
172.30.1.0 2 13.0.0.3 Te 1/47 1 Intra-Area
Dell#
show ip ospf statistics
Display OSPF statistics.
Syntax
show ip ospf [process-id | vrf vrf-name] statistics global |
[interface name {neighbor router-id}]
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first OSPF
process.
Open Shortest Path First (OSPFv2 and OSPFv3) 1442