Users Guide

Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support of Multi-Process OSPF.
7.8.1.0 Added the process-id option, in support of Multi-Process
OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series and E-Series.
Usage Information To isolate problems with external routes, use this command. In OSPF, external routes
are calculated by adding the LSA cost to the cost of reaching the ASBR router. If an
external route does not have the correct cost, use this command to determine if the
path to the originating router is correct. The display output is not sorted in any order.
NOTE: ASBRs that are not in directly connected areas are also displayed.
You can determine if an ASBR is in a directly connected area (or not) by the flags. For
ASBRs in a directly connected area, E flags are set. In the following example, router
1.1.1.1 is in a directly connected area since the Flag is E/-/-/. For remote ASBRs, the E
flag is clear (-/-/-/).
Example
Dell# show ip ospf 1asbr
RouterID Flags Cost Nexthop Interface Area
3.3.3.3 -/-/-/ 2 10.0.0.2 Te 1/1 1
1.1.1.1 E/-/-/ 0 0.0.0.0 - 0
Dell#
Open Shortest Path First (OSPFv2 and OSPFv3) 1415