Users Guide

Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Added output for LSA throttling timers.
8.3.7.0 Introduced on the S4810.
7.9.1.0 Added support for VRF.
7.8.1.0 Added support of Multi-Process OSPF.
7.8.1.0 Added the process-id option, in support of Multi-Process
OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage Information If you delete all the network area commands for Area 0, the show ip ospf command
output does not list Area 0.
The following describes the show ip ospf command shown in the following
example.
Line Beginning
with
Description
“Routing
Process...”
Displays the OSPF process ID and the IP address associated with
the process ID.
“Supports only...” Displays the number of Type of Service (TOS) rouse supported.
“SPF schedule...” Displays the delay and hold time configured for this process ID.
“Convergence
Level”
“Min LSA....” Displays the intervals set for LSA transmission and acceptance.
Open Shortest Path First (OSPFv2 and OSPFv3) 1413