Users Guide

Version Description
pre- 6.1.1.1 Introduced on the E-Series.
Usage Information
If this command is not configured, cost is based on the auto-cost command.
When you configure OSPF over multiple vendors, to ensure that all routers use the
same cost, use the ip ospf cost command. Otherwise, OSPF routes improperly.
Related
Commands
• auto-cost — control how the OSPF interface cost is calculated.
ip ospf dead-interval
Set the time interval since the last hello-packet was received from a router. After the interval elapses, the
neighboring routers declare the router dead.
S4048–ON
Syntax
ip ospf dead-interval seconds
To return to the default values, use the no ip ospf dead-interval command.
Parameters
seconds Enter the number of seconds for the interval. The range is from 1
to 65535. The default is 40 seconds.
Defaults 40 seconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Open Shortest Path First (OSPFv2 and OSPFv3) 1391