Users Guide

Usage Information The distribute-list out command applies to routes autonomous system
boundary routers (ASBRs) redistributes into OSPF. It can be applied to external type 2
and external type 1 routes, but not to intra-area and inter-area routes.
fast-convergence
This command sets the minimum LSA origination and arrival times to zero (0), allowing more rapid route
computation so that convergence takes less time.
S4048–ON
Syntax
fast-convergence {number}
To cancel fast-convergence, use the no fast convergence command.
Parameters
number Enter the convergence level desired. The higher this parameter
is set, the faster OSPF converge takes place. The range is from 1
to 4.
Defaults None.
Command Modes ROUTER OSPF
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on all platforms.
Usage Information
The higher this parameter is set, the faster OSPF converge takes place.
Open Shortest Path First (OSPFv2 and OSPFv3) 1383