Users Guide

Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to specify
the VRF that is used by the TFTP client.
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z9000.
Usage Information Use this command to make the TFTP clients VRF aware. The VRF name that you specify
is used by the TFTP client to reach the TFTP server. If no VRF is specified, then the
default VRF is used.
Related
Commands
• ftp-server topdir — sets the directory to be used for incoming FTP connections.
• ftp-server username — sets a username and password for incoming FTP
connections.
line
Enable and configure console and virtual terminal lines to the system. This command accesses LINE mode,
where you can set the access conditions for the designated line.
Syntax
line {aux 0 |console 0 | vty number [end-number]}
Parameters
aux 0 Enter the keyword aux 0 to configure the auxiliary terminal
connection.
console 0 Enter the keyword console 0 to configure the console port.
The console option is <0-0>.
vty number Enter the keyword vty then a number from 0 to 9 to configure
a virtual terminal line for remote sessions. The system supports
10 remote sessions.
Control and Monitoring 137