Users Guide

Usage Command The following describes the show track ipv6 route brief command shown in the
Example below.
Ouput Description
ResID Number of the tracked object.
Resource Type of tracked object.
Parameter Detailed description of the tracked object.
State Up or Down state of the tracked object.
Last Change Time since the last change in the state of the tracked object.
Example (Brief)
Dell# show track ipv6 route brief
ResId Resource Parameter State LastChange
2 IPv6 route metric threshold 2040::/64 Up 00:02:36
3 IPv6 route reachability 2050::/64 Up 00:02:36
Related
Commands
• show running-config track – display configuration information about tracked
objects.
• show track – display information about tracked objects, including configuration,
current state, and clients which track the object.
• track interface ipv6 routing – configure object tracking on the routing status of an
IPv6 Layer 3 interface.
• track ipv6 route metric threshold – configure object tracking on the threshold of
an IPv6 route metric.
• track ipv6 route reachability – configure object tracking on the reachability of an
IPv6 route.
track interface ipv6 routing
Configure object tracking on the routing status of an IPv6 Layer 3 interface.
Syntax
track object-id interface interface ipv6 routing
To return to the default setting, use the no track object-id command.
Parameters
object-id Enter the ID number of the tracked object. The range is 1 to 500.
interface Enter one of the following values:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
Object Tracking 1357