Users Guide

Output Description
Last Change Time since the last change in the state of the tracked object.
Example (Brief)
Dell> show track brief
ResId Resource Parameter State LastChange
1 IP route reachability 10.16.0.0/16 Up 00:01:08
2 Interface line-protocol Ethernet0/2 Down 00:05:00
3 Interface ip routing VLAN100 Up 01:10:05
Related
Commands
• show running-config track – display configuration information about tracked
objects.
• track interface ip routing – configure object tracking on the routing status of an
IPv4 Layer 3 interface.
• track interface line-protocol – configure object tracking on the line-protocol
state of a Layer 2 interface.
• track ip route metric threshold – configure object tracking on the threshold of an
IPv4 route metric.
• track ip route reachability – configure object tracking on the reachability of an
IPv4 route.
threshold metric
Configure the metric threshold used to determine the UP and/or DOWN state of a tracked IPv4 or IPv6 route.
Syntax
threshold metric {up number | down number}
To return to the default setting, use the no threshold metric {up number |
down number} command.
Parameters
up number Enter a number for the UP threshold to be applied to the scaled
metric of an IPv4 or IPv6 route. The default UP threshold is 254.
The routing state is UP if the scaled route metric is less than or
equal to the UP threshold.
down number Enter a number for the DOWN threshold to be applied to the
scaled metric of an IPv4 or IPv6 route. The default DOWN
threshold is255. The routing state is DOWN if the scaled route
metric is greater than or equal to the DOWN threshold.
Defaults None
Command Modes OBJECT TRACKING (conf_track_object-id)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Object Tracking 1346