Users Guide

Parameters
text Enter a description to identify a tracked object (80 characters
maximum).
Defaults None
Command Modes OBJECT TRACKING (conf_track_object-id)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Related
Commands
• track interface ip routing – configure object tracking on the routing status of an
IPv4 Layer 3 interface.
• track interface line-protocol – configure object tracking on the line-protocol
state of a Layer 2 interface.
• track ip route metric threshold – configure object tracking on the threshold of an
IPv4 route metric.
• track ip route reachability – configure object tracking on the reachability of a
specific IP address. Policy-based Routing uses the track command to track the
next-hop ip address.
show running-config track
Display the current configuration of tracked objects.
Syntax
show running-config track [object-id]
Parameters
object-id (OPTIONAL) Display information on the specified tracked object.
The range is 1 to 500.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Object Tracking 1342