Users Guide

• ipv6 nd raguard policy policy-name — define the router advertisement (RA) guard
policy name and enter the RA guard policy configuration mode.
match ra
Enable verifying either of the configured source IPv6 address or prefix address or the source MAC address in
the inspected messages. If this command is not configured, the verification process is bypassed.
Syntax
match ra {ipv6-access-list name | ipv6-prefix-list name | mac-
access-list name}
To reset the access list, use the no match ra{ipv6-access-list | ipv6-
prefix-list | mac-access-list}command.
Parameters
ipv6–access-list
name
Enter the keywords ipv6–access-list then the access-list
name. The access-list name allows a maximum of 140
characters.
ipv6–prefix-list
name
Enter the keywords ipv6–prefix-list then the prefix-list
name. The prefix-list name allows a maximum of 140
characters.
ipv6–mac-
access-list name
Enter the keywords ipv6–mac-access-list then the mac-
access-list name. The mac-access-list name allows a maximum
of 140 characters.
Defaults None
Command Modes POLICY LIST CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.9(0.0) Introduced on the Z9500.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and Z9000
switches.
Related
Commands
• ipv6 nd ra-guard enable — configure the RA guard related commands.
• ipv6 nd raguard policy policy-name — define the RA guard policy name and enter
the RA guard policy configuration mode.
Neighbor Discovery Protocol (NDP) 1330