Users Guide

To configure the IPv6 RA guard, use the following Dell Networking OS commands.
debug ipv6 nd ra-guard
Enable debugging for IPv6 RA guard snooping information.
Syntax
debug ipv6 nd ra-guard [interface_type slot/port | count value]
Parameters
interface_type
slot/port
Enter the one of the following interfaces and slot/port
information:
• For a port channel interface, enter the keywords port-
channel
then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
count value Enter the keyword count then the number of debug outputs.
The range is from 1 to 65534. The default is infinity.
Defaults None
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.9(0.0) Introduced on the Z9500.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON,
and Z9000 switches.
device-role
Specify the role of the device attached to the port.
Syntax
device-role {host | router}
To reset the device role, use the no device-role {host | router} command.
Neighbor Discovery Protocol (NDP) 1325