Users Guide
Command History
This guide is platform-specific. For command information about other platforms, see the
relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
Example
Dell# show ipv6 neighbors
IPv6 Address Expires(min) Hardware Address State Interface VLAN
CPU
--------------------------------------------------------------------
100::1 0.03 00:00:00:00:00:22 DELAY Te 1/12 - CP
fe80::200:ff:fe00:22 232 00:00:00:00:00:22 STALE Te 1/12 - CP
500::1 0.60 00:01:e8:17:5c:af REACH Te 1/13 - CP
fe80::200:ff:fe00:17 232 00:00:00:00:00:29 REACH Te 1/14 - CP
900::1 0.60 00:01:e8:17:5c:b1 STALE Po 23 - CP
400::1 0.60 00:01:e8:17:5c:ae REACH Te 1/2 Vl 100
CP
Dell#
IPv6 Router Advertisement (RA) Guard
The IPv6 RA guard provides support to perform conditional forwarding or blocking of the router
advertisement messages that are received at the network device platform. This functionality analyzes and
filters the RAs sent by the devices and compares the configuration information on the layer 2 device with the
RA frame. Once the layer 2 device validates the content of the RA frame against the configuration, it forwards
the RA to its unicast or multicast destination. On failure to validate the RA frame content, the RA frame is
dropped.
The IPv6 RA guard supports two different modes:
• Host mode — When a policy with device role as host is applied on an interface, all the RA packets are
dropped without validation. You can also configure the host mode policy with VLAN option to drop the
RA packets on that specific VLAN and port.
• Router mode — When a policy with device role as router is applied on an interface, all the RA packets
are validated based on the configuration information in the policy. Similarly, you can also apply this
mode over any specific VLAN and the validation is performed only for that particular VLAN RA packets.
Neighbor Discovery Protocol (NDP) 1324