Users Guide

ip msdp sa-filter
Permit or deny MSDP source active (SA) messages based on multicast source and/or group from the specified
peer.
Syntax
ip msdp sa-filter {in | out} peer-address list [access-list name]
Remove this configuration using the no ip msdp sa-filter {in | out} peer
address list [access-list name] command.
Parameters
in Enter the keyword in to enable incoming SA filtering.
out Enter the keyword out to enable outgoing SA filtering.
peer-address Enter the peer address of the MSDP peer in a dotted decimal
format (A.B.C.D.).
access-list name Enter the name of an extended ACL that contains permitted SAs.
If you do not use this option, all local entries are blocked.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Multicast Source Discovery Protocol (MSDP) 1282