Users Guide

sa-limit number (OPTIONAL) Enter the maximum number of SA entries in SA-
cache. The range is from 1 to 100000. .
Defaults See Parameters .
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
7.5.1.0 Added option for SA upper limit and the description option.
6.2.1.1 Introduced
Usage Information
The connect-source option is used to supply a source IP address for the TCP
connection. When an interface is specified using the connect-source option, the
primary configured address on the interface is used.
If the total number of SA messages received from the peer is already larger than the
limit when this command is applied, those SA messages continue to be accepted. To
enforce the limit in such situation, use the clear ip msdp peer command to reset
the peer.
Related
Commands
• ip msdp sa-limit — configure the MSDP SA Limit.
• clear ip msdp peer — clear the MSDP peer.
• show ip msdp — display the MSDP information.
Multicast Source Discovery Protocol (MSDP) 1280