Users Guide

Version Description
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
6.2.1.1 Introduced
ip msdp peer
Configure an MSDP peer.
Syntax
ip msdp peer peer address [connect-source] [description] [sa-limit
number]
To remove the MSDP peer, use the no ip msdp peer peer address [connect-
source interface] [description name] [sa-limit number] command.
Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.).
connect-source
interface
Enter the keywords connect-source then one of the
interfaces and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-
channel then a number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
description name (OPTIONAL) Enter the keyword description then a description
name (maximum 80 characters) to designate a description for
the MSDP peer.
Multicast Source Discovery Protocol (MSDP) 1279