Users Guide

ip msdp mesh-group
To be a member of a mesh group, configure a peer.
Syntax
ip msdp mesh-group {name} {peer address}
To remove the peer from a mesh group, use the no ip msdp mesh-group {name}
{peer address} command.
Parameters
name Enter a string of up to 16 characters long for as the mesh group
name.
peer address Enter the peer address in a dotted decimal format (A.B.C.D.).
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
6.2.1.1 Introduced
Usage Information An MSDP mesh group is a mechanism for reducing SA flooding, typically in an intra-
domain setting. When some subset of a domain’s MSDP speakers are fully meshed, they
can be configured into a mesh-group. If member X of a mesh-group receives a SA
message from an MSDP peer that is also a member of the mesh-group, member X
Multicast Source Discovery Protocol (MSDP) 1277