Users Guide

interface option with the mac-address-table
static command.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.3(0.0) Added support for association of an IP address with multicast
MAC address on the S4810, S4820T, S6000, and Z9000
platforms.
Usage Information For multicast mode of NLB, to associate an IP address with a multicast MAC address in
the switch, use address resolution protocol (ARP) by entering the arp ip-address
multicast-mac-address command in Global configuration mode. This setting
causes the multicast MAC address to be mapped to the cluster IP address for NLB
mode of operation of the switch.
Related
Commands
• clear arp-cache — clear dynamic ARP entries from the ARP table.
• show arp — display the ARP table.
mac-address-table static (for Multicast
MAC Address)
For multicast mode of network load balancing (NLB), configure a static multicast MAC address, associate the
multicast MAC address with the VLAN used to switch Layer 2 multicast traffic, and add output ports that will
receive multicast streams on the VLAN. To delete a configured static multicast MAC address from the MAC
address table on the router, enter the
no mac-address-table static multicast-mac-address
command.
Syntax
mac-address-table static multicast-mac-address multicast vlan
vlan-id range-output {single-interface | interface-list |
interface-range}
To remove a MAC address, use the no mac-address-table static multicast-
mac-address output interface vlan vlan-id command.
Parameters
multicast-mac-
address
Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn
format.
Microsoft Network Load Balancing 1266