Users Guide

Column
Heading
Description
State Lists if the MAC address is in use (Active) or not in use (Inactive).
Example
Dell(conf)# do show mac-address-table
Codes: *N - VLT Peer Synced MAC
VlanId Mac Address Type Interface State
2 00:00:00:00:00:01 Dynamic (N) Po 128 Active
2 00:00:00:00:00:02 Dynamic (N) Po 10 Active
2 00:00:00:00:00:03 Dynamic Po
100 Active
2 00:00:00:00:00:04 Dynamic Po
10 Active
Usage Information The following describes the show mac-address-table count command shown in
the following example.
Line Beginning
With
Description
MAC Entries... Displays the number of MAC entries learned per VLAN.
Dynamic
Address...
Lists the number of dynamically learned MAC addresses.
Static Address... Lists the number of user-defined MAC addresses.
Total MAC... Lists the total number of MAC addresses the switch uses.
Example (Count)
Dell# show mac-address-table count
MAC Entries for all vlans :
Dynamic Address Count : 110
Static Address (User-defined) Count : 0
Sticky Address Count : 0
Total Synced Mac from Peer(N): 100
Total MAC Addresses in Use: 110
Dell#
Related
Commands
• show mac-address-table aging-time — display MAC aging time.
show mac-address-table aging-time
Display the aging times assigned to the MAC addresses on the switch.
Syntax
show mac-address-table aging-time [vlan vlan-id]
Layer 2 1206