Users Guide

Version Description
pre-6.2.1.1 Introduced on the E-Series.
Example (Unicast)
mac-address-table static 00:01:00:00:00:01 {output Te 1/2 vlan 2}
Example
(Multicast)
mac-address-table static 01:00:5E:01:00:01 {multicast vlan
2 output—range Te 1/2, Te 1/3}
Related
Commands
• show mac-address-table — display the MAC address table.
mac-address-table station-move threshold
Change the frequency with which the MAC address station-move trap is sent after a MAC address changes in
a VLAN. A trap is sent if a station move is detected above a threshold number of times in a given interval.
Syntax
[no] mac-address-table station-move threshold number interval
count
Parameters
threshold number Enter the keyword threshold then the number of times MAC
addresses in VLANs can change before an SNMP trap is sent. The
range is from 1 to 10.
interval seconds Enter the keyword interval then the number of seconds. The
range is from 5 to 60.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Usage Information For information about the specific trap sent and the corresponding Syslog, see
SNMP Traps.
Layer 2 1193