Users Guide

Version Description
8.3.12.0 Introduced on the S4810.
Example
The bold section identifies that Multi-Topology IS-IS is enabled.
Dell# show isis protocol
IS-IS Router: <Null Tag>
System Id: F100.E120.0013 IS-Type: level-1-2
Manual area address(es):
49.0000.0001
Routing for area address(es):
49.0000.0001
Interfaces supported by IS-IS:
TenGigabitEthernet 1/1 - IP - IPv6
TenGigabitEthernet 1/2 - IP - IPv6
TenGigabitEthernet 1/10 - IP - IPv6
Loopback 0 - IP - IPv6
Redistributing:
Distance: 115
Generate narrow metrics: level-1-2
Accept narrow metrics: level-1-2
Generate wide metrics: none
Accept wide metrics: none
Multi Topology Routing is enabled in transition mode.
Dell#
show isis traffic
This command allows you to display IS-IS traffic interface information.
Syntax
show isis [vrf vrf-name] traffic [interface]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the
VRF to display IS-IS traffic interface information corresponding
to that VRF.
interface (OPTIONAL) Identifies the interface type and the interface
following:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number.
Intermediate System to Intermediate System (IS-IS) 1175