Users Guide

Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Replacement command for the S4820T. Replaces the enable
xfp-power-updates command.
8.3.11.4 Replacement command for the Z9000. Replaces the enable
xfp-power-updates command
8.3.10.0 Replacement command for the S4810 only. Replaces the
enable xfp-power-updates command.
Usage Information To enable polling and to configure the polling frequency, use this command.
enable xfp-power-updates
Enable 10–gigabit small form-factor pluggable (XFP) power updates for SNMP.
Syntax
enable xfp-power-updates interval seconds
Parameters
interval seconds Enter the keyword interval then the polling interval in
seconds. The range is from 120 to 6000 seconds. Default: 300
seconds (5 minutes).
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
8.3.19.0 Deprecated command for S4820T. Replaced by the enable
optic-info-update interval command to update
Control and Monitoring 116