Users Guide

Version Description
9.5(0.0) Added support for roles on the Z9000, S6000, S4820T, S4810,
and MXL.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information Users entering EXEC Privilege mode or any other configured privilege level can access
configuration commands. To protect against unauthorized access, use the enable
password command to configure a password for the enable command at a specific
privilege level. If no privilege level is specified, the default is privilege level
15.
NOTE: If you are authorized for the EXEC Privilege mode by your role, you do not
need to enter an enable password.
Related
Commands
• enable password — configures a password for the enable command and to
access a privilege level.
enable optic-info-update interval
Enable polling intervals of optical information updates for simple network management protocol (SNMP).
Syntax
enable optical-info-update [interval seconds]
To disable optical power information updates, use the no enable optical-info-
update interval command.
Parameters
interval seconds Enter the keyword interval then the polling interval in
seconds. The range is from 120 to 6000 seconds. The default is
300 seconds (5 minutes).
Defaults Disabled
Command Modes CONFIGURATION
Control and Monitoring 115