Users Guide

max-area-addresses
Configure manual area addresses.
Syntax
max-area-addresses number
To return to the default values, use the no max-area-addresses command.
Parameters
number Set the maximum number of manual area addresses. The range
is from 3 to 6. The default is 3.
Defaults 3 addresses
Command Modes ROUTER ISIS
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.5.1.0 Added support for LSP Throttling Enhancement.
Usage Information To configure the number of area addresses on router, use this command. This value
must be consistent with routers in the same area, otherwise the router forms only Level
2 adjacencies. The value must be same among all the routers to form Level 1
adjacencies.
Intermediate System to Intermediate System (IS-IS) 1149