Users Guide

loopback (OPTIONAL) View information for IPv6 Loopback interfaces.
port-channel (OPTIONAL) View information for IPv6 port channels.
tengigabitethernet (OPTIONAL) View information for an IPv6 tengigabitethernet
interface.
fortyGigE (OPTIONAL) View information for an IPv6 fortygigabitethernet
interface.
stack-unit id (OPTIONAL) View information for stacking.
tunnel tunnel-id (OPTIONAL) View information for a tunnel interface.
vlan (OPTIONAL) View information for IPv6 VLANs.
Defaults None
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1)
Added support for IPv6 recursive DNS addresses on the Z9500.
9.2(1.0) Introduced on the Z9500.
9.2.(0.0) Added support for tunnel interface.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.4.2.1 Introduced on the S-Series.
8.2.1.0 Introduced on the E-Series. Added support for the
managementethernet slot/port parameter.
7.8.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information The Management port is enabled by default (no shutdown). If necessary, use the ipv6
address command to assign an IPv6 address to the Management port.
Example
Dell# show ipv6 interface tengigabit 1/12
TenGigabitEthernet 1/12 is up, line protocol is up
IPv6 Basics 1082