Users Guide

Enter 4 or 8 for the number of OpenFlow FP blocks.
• 4: Creates 242 entries for use by the OpenFlow controller
(256 total entries minus the 14 entries reserved for internal
functionality)
• 8: Creates 498 entries for use by the OpenFlow controller
(512 total entries minus the 14 entries reserved for internal
functionality)
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.2(0.2) Added support for the fcoe parameter on the S4810 and
S4820T.
9.1.(0.0) Added support for OpenFlow on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Added the keywords fcoeacl and iscsioptacl on the S4810.
8.3.11.1 Introduced on the Z9000.
8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-
qos.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information
For the new settings to take effect, save the new CAM settings to the startup-config
(write-mem or copy run start) then reload the system.
The total amount of space allowed is 16 FP Blocks. System flow requires three blocks
and these blocks cannot be reallocated. The ipv4acl profile range is from 1 to 4.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Control and Monitoring 108