Users Guide

preferred-lifetime
| infinite
Enter the amount of time that the prefix is preferred, or enter
infinite for an unlimited amount of time. The range is from 0
to 4294967295. The default is 604800. The maximum value
means that the preferred lifetime and does not expire.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.2.0 Introduced on the E-Series, C-Series, and S-Series.
Usage Information By default, all prefixes configured as addresses on the interface are advertised. This
command allows control over the individual parameters per prefix; you can use the
default keyword to use the default parameters for all prefixes. If a prefix has been
configured with lifetime parameter values, the default values cannot be applied using
the ipv6 nd prefix default no-autoconfig command.
ipv6 route
Establish a static IPv6 route.
Syntax
ipv6 route [vrf vrf-name] ipv6-address prefix-length {ipv6-address
| interface | interface ipv6-address} [distance] [tag value]
[permanent] [weight weight-value]
To remove the IPv6 route, use the no ipv6 route command.
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the
VRF to install IPv6 routes in that VRF.
IPv6 Basics 1073