Users Guide

Usage Information This command allows you to create an EUI64 address based on the specified prefix and
MAC address only. Prefixes may be configured on the interface using the ipv6 nd
prefix command without creating an EUI64 address.
Example
Dell(conf)# int ten 1/4
Dell(conf-if-te-1/4)# ipv6 address 200:1::/64 eui64
Dell(conf)# int ten 1/6
Dell(conf-if-te-1/6)# ipv6 address 801:10::/64 eui64
ipv6 control-plane icmp error-rate-
limit
Configure the maximum number of ICMP error packets per second that can be sent per second.
Syntax
ipv6 control-plane icmp error-rate-limit {1-200}
To restore the default value, use the no ipv6 control-plane icmp error-rate-
limit command.
Parameters
pps Enter the maximum number of error packets generated per
second. The range is from 1 to 200, where 0 disables the rate-
limiting.
Default 100 pps
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
IPv6 Basics 1067